Vertical grab bar requirements a vertical grab bar 18 455 mm minimum in length mounted along the side wall.
Vertical grab bar location.
Two grab bars shall be installed on the back wall one located in accordance with 609 4 and other located 8 inches 205 mm minimum and 10 inches 255 mm maximum above the rim of the bathtub.
This is normally a small grab bar positioned vertically.
Vertical grab bar placement the grab bar can be mounted into a stud if located that sits behind the wall or optionally mounted using approved anchoring devices such as snap toggles flip toggles or securemount anchors when a stud cannot be identified in a convenient location.
You can mount a grab bar horizontally vertically and diagonally.
Vertical placement especially meets the weakness that one might have standing up from a bench or chair in the shower.
On the wall at the entrance to the shower stall.
It should be about 30 inches up from the tub floor.
This is usually a longer bar positioned horizontally.
In toilets and showers the tops of horizontal grab bars need to be 33 to 36 inches from the floor.
There should be a minimum of 3 grab bars in a standard shower stall.
By the faucet handles or near them.
Rear wall grab bars shall be 36 915 mm long and mounted so 24 610 mm are to the transfer side of the toilet and the other 12 305 mm to the wall side.
Near the toilet is another good place to install a grab bar.
All three directions can be used in the tub.
If you sit down on a shower chair diagonally may be the best direction for the bar nearest your chair.
Bottom of the bar located 39 990 mm minimum and 41 1040 mm maximum above the floor.
They should be position in the following spots.
For placing grab bars in your bath tub or bathtub shower combination use these tips.
On the side wall.
Although diagonal bars can meet the initial phase of sit to stand it is much easier to pull on a vertical bar to stand than on a diagonal or horizontally placed one.
Remember that you can adjust that bench up and down.
The rear grab bar can be split or shifted to the open side to accommodate the required location of the flush control valves.
The problem is that installers often aim for one edge of the range and end up a bit high or low.
Dimensions for rear grab bar installation.
Center line of the bar located 39 990 mm minimum and 41 1040 mm maximum from the rear wall.
And the horizontal bar that s attached to the side wall should be as long as possible and installed a little lower about 30 inches from the tub floor.
Each grab bar shall be 24 inches 610 mm long minimum and shall be installed 24 inches 610 mm maximum from the head end wall and 12 inches 305 mm maximum from the control end wall.
In a transfer shower the bottom of the vertical bar must be 3 to 6 inches above the horizontal bar on that wall.
The vertical entrance bar is the same but should always be installed on the end wall opposite the faucet wall.
Vertical entrance bar should be installed on the wall opposite the faucet.
